1022 — Uther Ipamorelin
Independently TestedUther | Ipamorelin, last activity 4 hours ago
2 related batch concerns
Get notified when a lab result is posted, a group test forms, or this batch is flagged by the community.
Share in Telegram →Look up lots from Telegram: @PepBatchBot→
Test Results
Dosing with this lot
The label says 10 mg. Janoshik weighed 11.2 mg — 12% more than the label. Your dose depends on what is really in the vial, so the calculator uses the measured amount.
Draw
18 units
on a U-100 insulin syringe, for 1 mg
Going by the label you would draw 20 units — which from this vial is actually 1.12 mg, not 1 mg.
- The vial holds dry powder: 11.2 mg of Ipamorelin, as weighed.
- Water spreads that powder evenly through the liquid: 11.2 mg ÷ 2 ml = 5.59 mg per ml.
- An insulin syringe counts in units, 100 to the ml, so each unit carries 56 mcg.
- Your dose divided by that: 1 mg ÷ 56 mcg = 18 units.
The water changes how many units a dose takes, never how much peptide you get. Twice the water means twice the units for the same dose. What sets the dose is how much is in the vial — which is why the measured amount matters.
Arithmetic, not medical advice. Assumes a U-100 syringe and that the powder fully dissolves. The figure is from the vial that was tested; yours is from the same lot but was not weighed itself.
Related batches
5 of 5 tested
also Uther
A community group test with Janoshik is forming (2 participants so far)
PT-141, same vendor
One concern was raised about this batch
GYC/GGpeps
Vendor certificate from Freedom Diagnostics Testing shows 99.61% purity and 8.17 mg measured fill
also Uther
Uther published three certificates from Janoshik for this batch
also Uther
The vial measured 11.98mg against a 10mg label—about 20% over
Community Intelligence
Activity
No community activity tracked yet.
Vendor
Uther