BP10-0813 — Uther BPC-157
Vendor COAUther | BPC-157, last activity 1 week ago
Uther has published two certificates from Janoshik for this batch, showing purity at 99.86% and 99.65% with fill measurements of 11.89 mg and 13.61 mg. Two quality concerns were raised and two test requests submitted, giving this batch roughly twice the typical discussion rate for its age. Purity is consistent with Uther's other BPC-157 batches. No independent test has been submitted.
2 direct concern reports · 2 test requests · 4 related batch concerns · 7 mentions · summary from 9 sources · updated Oct 13
Get notified when a lab result is posted, a group test forms, or this batch is flagged by the community.
Test Results
Dosing with this lot
The label says 10 mg. Janoshik weighed 11.9 mg — 19% more than the label. Your dose depends on what is really in the vial, so the calculator uses the measured amount.
Draw
17 units
on a U-100 insulin syringe, for 1 mg
Going by the label you would draw 20 units — which from this vial is actually 1.19 mg, not 1 mg.
- The vial holds dry powder: 11.9 mg of BPC-157, as weighed.
- Water spreads that powder evenly through the liquid: 11.9 mg ÷ 2 ml = 5.95 mg per ml.
- An insulin syringe counts in units, 100 to the ml, so each unit carries 59 mcg.
- Your dose divided by that: 1 mg ÷ 59 mcg = 17 units.
The water changes how many units a dose takes, never how much peptide you get. Twice the water means twice the units for the same dose. What sets the dose is how much is in the vial — which is why the measured amount matters.
Arithmetic, not medical advice. Assumes a U-100 syringe and that the powder fully dissolves. The figure is from the vial that was tested; yours is from the same lot but was not weighed itself.
Related batches
5 of 5 tested
same lot series
This batch is drawing unusual interest for its age, with a community group test forming at Janoshik
same lot series
A community group test is forming with ILS Labs (3 participants so far)
also Uther
Uther's BPC-157 batch is getting unusual attention for its age, with one concern and one negative report against two…
PT-141, same vendor
One concern was raised about this batch
SPB
A community group test is forming with three participants
Community Intelligence
- 2 direct concern reports
- 2 test requests
- 1 concern report involving USBP100813
- 1 concern report involving PT10-0528
- 2 concern reports involving PT10-0617
- 2 concern reports involving PYQI
Reported against other Uther BPC-157 batches, not this one.
Also known as: BP100813US-BP10-0813
Activity
[https://verify.janoshik.com/tests/225773-Us_bpc_10mg_10030_USBP100813_8D4FCD68AW96](https://verify.janoshik.com/tests/225773-Us_bpc_10mg_10030_USBP100813_8D4FCD68AW96)
View in Telegram →members onlyThe photo does not match BP10-0813
View in Telegram →members onlySo last year's BP10 from 13th August
View in Telegram →members onlyHi Dave, I have the BP10-0813 batch but the color cap does not match the COA
View in Telegram →members onlyHi has anyone seen a test report for this batch of BPC-157, batch number BP10-0813
View in Telegram →members onlyHi Do we have a COA for this Batch of BPC-157, BP10-0813
View in Telegram →members onlyVendor
Uther