M3P0S03-1J — M-Peptide Science Retatrutide

The label says 30 mg. Janoshik weighed 32.4 mg — 8% more than the label. Your dose depends on what is really in the vial, so the steps below use the measured amount.

Going by the label you would draw 20 units — which from this vial is actually 3.24 mg, not 3 mg.

1. The vial holds dry powder: 32.4 mg of Retatrutide, as weighed.
2. Water spreads that powder evenly through the liquid: 32.4 mg ÷ 2 ml = 16.2 mg per ml.
3. An insulin syringe counts in units, 100 to the ml, so each unit carries 162 mcg.
4. Your dose divided by that: 3 mg ÷ 162 mcg = 19 units.

The water changes how many units a dose takes, never how much peptide you get. Twice the water means twice the units for the same dose. What sets the dose is how much is in the vial — which is why the measured amount matters.

Arithmetic, not medical advice. Assumes a U-100 syringe and that the powder fully dissolves. The figure is from the vial that was tested; yours is from the same lot but was not weighed itself.